2341 SE Federal Hwy, Stuart Centre Mon–Fri 9–6 · Sat 9–5

How to choose frames for your face and your prescription

The answer

Choose frames in this order: fit first (bridge, temple length and overall width), then what your prescription needs (smaller, rounder lenses for strong prescriptions, enough lens height for progressives), then material and how you live. In Florida, that means sun, heat and salt air. Face-shape rules are a loose guide; a frame that fits well usually looks right.

Most advice about choosing frames starts with face shape: round faces in angular frames, square faces in round ones. It is not wrong, exactly, but it is the least important part of the decision. A frame that does not fit your bridge, or does not suit your prescription, will be uncomfortable or look off no matter how well it matches your face shape.

So this guide works in the order an optician would: fit, then prescription, then material and lifestyle, then style. If you want to see what is actually on the wall, start at eyewear brands in Stuart.

Fit first: bridge, temples and width

The bridge carries most of the weight of your glasses, so it matters most. A frame with a fixed bridge, common on acetate frames, needs to rest flat on your nose without gaps or pinching. If it sits too high or too low, the frame either slides down or rides up into your eyebrows. Frames with adjustable nose pads, common on metal frames, can be tuned to almost any nose, which makes them a good choice if fixed bridges never fit you. People with a low or flat bridge often do better with adjustable pads or a frame designed for a lower bridge fit.

The temples should run straight back to your ears and bend down behind them without pressing on the sides of your head. Too short and they dig in behind the ear. Too long and the frame never stays put.

The overall width should roughly match the width of your face at the temples. A frame that is too narrow pinches and leaves marks. A frame that is too wide slides and puts your eyes too close to the inside edge of each lens.

Most frames carry three numbers on the inside of a temple: lens width, bridge width and temple length, in millimeters. If you have an old pair that fit well, those numbers are a sensible place to start.

Then your prescription

Your prescription narrows the field, sometimes quite a lot. This is where an optician’s input is most useful, because it is hard to judge from a mirror.

Strong minus (nearsighted) prescriptions

Minus lenses are thinnest in the center and thicker toward the edges. The larger the lens, and the further the edge sits from your eye’s line of sight, the thicker that edge gets. A strong minus prescription therefore looks and feels better in a smaller, rounder lens shape, ideally one where your eyes sit close to the center of each lens. Wide, tall or sharply angled shapes put more lens out at the thick edge. A full-rim frame also hides edge thickness better than a rimless or semi-rimless one. High-index material helps further, and it helps most when the frame choice is already working with it.

Strong plus (farsighted) prescriptions

Plus lenses are thickest in the center. A smaller frame lets the lens be made thinner and lighter overall, and reduces the magnified look strong plus lenses give to the eyes.

Progressives

A progressive lens needs room. It carries distance vision at the top and reading at the bottom, with a corridor between them, so the frame needs enough lens height below your pupil to fit the whole thing. Very shallow frames can cut off part of the reading area, which leaves you hunting for it. The exact minimum depends on the lens design and on where your eyes sit in the frame, so have an optician check a frame against your fitting height before you settle on it. Progressive lenses: what you are actually paying for explains the lens side.

Low prescriptions

If your prescription is mild, you have the most freedom. Large frames, rimless designs and unusual shapes are all realistic, and lens thickness is rarely the deciding factor.

Material

  • Acetate is a plastic that comes in a wide range of colors and patterns and can be adjusted with heat. It is comfortable and durable, but can warp if left somewhere very hot.
  • Titanium is light, strong and resists corrosion. It usually costs more, and it suits all-day wear and salt air.
  • Other metals are thin and adjustable, and can look lighter on the face than acetate. They are worth keeping an eye on in salt air, particularly at the hinges and screws.
  • Rimless and semi-rimless frames are light and nearly invisible, but they show lens edges, so they suit mild prescriptions better than strong ones.

Florida: sun, heat and salt air

Living on the Treasure Coast changes the math a little.

Heat. A closed car in a Stuart summer gets very hot. Glasses left on the dashboard can warp, and lens coatings can be damaged by high heat. Keep them in a case and out of direct sun in the car.

Salt air and water. Salt spray and sweat are hard on metal parts, hinges and screws. If you fish, boat or spend time at the beach, a frame that resists corrosion is worth the money, and rinsing your glasses with fresh water after a day on the water helps whatever they are made of.

Sun. Bright Florida light is why many people here end up with a dedicated pair of prescription sunglasses rather than relying on everyday glasses. Wraparound and larger shapes block more light from the sides, but check the prescription limits above before choosing one. See sunglasses for more.

Where style comes in

Once fit and prescription have narrowed the field, style has more room than people expect. A few loose guidelines are useful: the top of the frame often looks best following your brow line, and a frame in proportion to your face usually looks more natural than one much bigger or smaller. Beyond that, the frame you like wearing is the right one. Face-shape charts are a place to start if you are stuck, not a rule to obey.

The honest point here is that you do not need an expensive frame to get a good fit. A well-fitting everyday frame beats a designer frame that slides down your nose. At Schmidt’s, complete single-vision pairs start at $28 on a selected range of frames, and every frame gets the same fitting and free adjustments for as long as you own it. See current offers.

If your prescription is out of date, start with an eye exam. Exams are available in our building from SeeCoast Eye Care, an independent practice; see eye exams.

Related questions

What do the numbers on the inside of my frame mean?

Most frames are marked with three measurements in millimeters: the lens width, the bridge width and the temple length. If you have a pair that fits well, those numbers are a useful starting point for the next one, though frames with the same numbers can still fit differently.

Can any frame take a progressive lens?

Not every frame. A progressive needs enough vertical lens height below your pupil to fit the corridor and reading area. Very shallow frames can cut part of that off. An optician can check a frame against your fitting height before you commit.

Are titanium frames worth it near the beach?

Titanium resists corrosion and is light and strong, which suits salt air and all-day wear. It usually costs more. Other metal frames can work well too, as long as you rinse them with fresh water after salt exposure and keep the hinges and screws checked.

Why do my glasses keep sliding down my nose?

Usually the bridge or nose pads do not match your nose, or the temples have loosened. An adjustment often fixes it. If the bridge is simply the wrong shape for your nose, a frame with adjustable nose pads or a different bridge fit is the longer-term answer.

The short version

  • Fit comes first: the bridge should sit flat, the temples should reach your ears, and your eyes should sit near the center of each lens.
  • Strong minus prescriptions look and feel better in smaller, rounder lenses.
  • Progressives need a frame with enough lens height for the reading zone.
  • In Florida, think about heat, sun and salt air when choosing material.
  • Face-shape rules are a loose starting point, not a rulebook.

Questions? Call (772) 283-2622 and ask for an optician. Call (772) 283-2622 · Eyewear brands in Stuart →

Keep reading

Related guides

Eyewear · 6 min read

Buying glasses online vs in person: when each one makes sense

Online suits simple, low prescriptions and spares. Progressives, strong prescriptions and kids do better in person.

Read the guide →

Lenses · 6 min read

Progressive lenses: what you are actually paying for

Lens design, material, coatings and fitting drive progressive prices. Sometimes the basic lens is the right buy.

Read the guide →

Visit Schmidt’s

Address
Schmidt's Optical & Hearing
2341 SE Federal Hwy, Stuart Centre
Stuart, FL 34994
Serving Stuart and all of Martin County, from Palm City to Jensen Beach and Hobe Sound.
Hours
Mon–Fri 9:00 AM – 6:00 PM
Saturday 9:00 AM – 5:00 PM
Sunday Closed
Phone
Optical (772) 283-2622
Hearing (772) 286-4327

Most major vision plans are accepted for frames and lenses. Bring your card and we will verify your benefit before anything is ordered.

Schmidt's Optical & Hearing storefront at 2341 SE Federal Hwy, Stuart Centre, Stuart FL
Site Designed and Developed by Trusted Marketing, LLC (opens in a new tab)
Call Get directions (opens in a new tab)